I’ve set up a Facebook page specific to 3D printing. I think this will make it a lot easier to make small updates that don’t seem to warrant a full blog post. Check it out!
|
||||
2 comments to Check out my Facebook Page!Leave a Reply to Pat Boyd Cancel reply |
Worthwhile Links: |
|||
Hi Michael,
Now that you have several MakerFarm printers with the 12″ on the way any suggestions for me?
I ordered the 12″ last week and was planning on sealing & painting the frame to keep moisture out. Any thoughts on that?
Any thing I should look for in the assembly?
Thanks for all the great reviews. You cover every performance issue a potenial buyer would need to know.
Thanks for the kind words!
The only caution on sealing and painting is that the fit might get a little tight. You may want to consider masking off the mating sections. The build videos are pretty good, just take your time and review them before you actually start.